ST2516 Series Operation Manual
25
Touch this soft key to set the language as English.
Chinese
Touch this soft key to set the language as Chinese.
You can touch soft keys to set corresponding functions.
4.1.3
Password
The function is used to set the password.
Steps for setting the password
Touch
Password
, the following soft keys will be displayed:
OFF
Touch this key to turn off the password protection function. This function would be disabled only
when the preset password is correctly input.
LOCK SYSTEM
Touch this key to enable the password function. Please input the password which will be required
to be input when opening a file or starting up the instrument.
LOCK FILE
It is necessary to input the password if this function is enabled.
MODIFY
Touch this key to modify the password.
Steps for modify the password:
Touch
MODIFY
, a numeric keyboard will pop up then you should input the original password and
press [ENTER] to confirm. Input the new password when the numeric keyboard is shown once
again and press [ENTER] to confirm. Then the numeric keyboard will be displayed for the third
time, please input the new password. Press [ENTER] to finish the password modification.
NOTE:
The default password is 2516.
4.1.4
Bus Mode
Touch this zone to select the communication interface.
Steps for setting the bus mode
1)
Touch
Bus Mode
, the following soft keys will be displayed:
RS232C
USBTMC
USBVCOM
2)
Touch
RS232C
to select the RS232C interface.
3)
Touch
USBTMC
to select the USBTMC interface. The instrument communicates with PC
through the USB interface on the rear panel.
4)
Touch
USBVCOM
to select the USBVCOM interface. The instrument communicates with PC
through the USB interface on the rear panel.