ST2516 Series Operation Manual
23
Figure 3-7 Bin Setup
On this page you can set all parameters concerned with the bin comparator. There are 3 groups
of parameters (high and low limits, nominal value, %) can be set.
The following parameters can be set on this page:
BIN
: Touch 1, 2, 3 below the bin, a
Delete
soft key will be displayed which can be used to
clear the high and low limits, nominal value, % of the bin.
STATE
: Display the bin state as ON or OFF. When ON is set, the corresponding bin in the
display zone will be shown as lighted circle. When OFF is set, the corresponding bin is shown
as a horizontal line.
TOOLS:
Touch TOOLS, the following soft keys will be displayed: MODE, BEEP and CLEAR.
Touch
MODE
to select ABS (Absolute value error mode) or % (percentage error) and
correspondingly high and low limits, nominal value, %. Press the touch key of the
corresponding bin, a numeric keyboard will pop up and you can set the relevant parameters
of the values. There are three bin beep modes: OFF, GD and NG.
CLEAR
can clear the setting
parameters of all the three bins.
