ST2516 Series Operation Manual
14
tested values and the set ones so as to judge the DUT is HI or LO or IN.
The set upper limit value
should be equal or larger than the lower limit value.
2)
% (percent error)
In this mode, you can set the nominal value and the percent error. If you set the nominal value as
100 and percent as 10, the set value should be 100±10%. The instrument will take comparison
between the tested values and the set ones so as to judge the DUT is HI or LO or IN.
The nominal
value is the base value in bias display mode.
3.3
<BIN DISP>
Touch <MEAS DISP> or press [MEAS]. Then select the soft key
BIN DISP
to enter into <BIN DISP>
shown as figure 3-3.
FILE
TOOLS
MEAS
DISP
COMP
DISP
BIN
DISP
MORE 1/2
11:36:54
STATIS
DISP
<BIN DISP>
BIN
ON
BIN BEEP
NG
NG COLOR
RED
GD COLOR
GREEN
R: 479.67
Ω
BIN:
Figure 3-3 Bin display
The following parameters can be set on <BIN DISP>.
FILE
1)
File Manage: Touch this key to enter into the file manage page.
2)
Screen Copy: Touch this key to save the current screen page to an external U disk. If no U
disk is found, this function will be disabled.
3)
Save Data OFF: Touch this key, this key will turn to <Save Data ON> and each measurement
result will be continuously saved to the .CSV file in U disk. Before a U disk is inserted, the
save function will be disabled. Press the key again, this key will turn to <Save Data OFF> and
the measurement result will not be saved. When switching between ON and OFF once, a
new .CSV file will be created in a U disk. The measurement data can be analyzed by opening
the file through the computer.
TOOLS
DISP (ON/OFF): ON is to display the result while OFF is not to.
BIN
BIN ON/OFF: ON is to turn on bin compare display while OFF is to turn off.
BIN BEEP ON/OFF
OFF is to turn off the bin beep function.
