SRP-X500P RS-232C Interface Manual
•
PROJECTOR ON/STANDBY INDICATOR (1st byte)
Shows the status of the PROJECTOR ON/STANDBY POWER switch.
The parameter and the status of the PROJECTOR ON/STANDBY POWER switch are as shown
in the following table.
PROJECTOR ON/STANDBY INDICATOR
STANDBY (The switch lights up red.)
0x30 (‘0’)
ON (The switch lights up red.)
0x31 (‘1’)
Cool off before entering STANDBY (the switch flashes green.)
0x32 (‘2’)
Example
When the projector is cooling off before entering standby (the switch flashes green)
0x41 0x32 0x0D
(‘A 2 CR’)
2.1.16 SCENE RECALL : 0x43 0x52 0x43 0x4C (‘CRCL’)
This command is used to recall a scene.
Note
This command can be used only when the SYSTEM TYPE selector on the SRP-X500P is set to 0.
Packet format
0x43 0x52 0x43 0x4C
“
parameter” 0x0D
♦
Parameter
The parameter consists of 1 byte of data.
Byte Parameter
1st
SCENE RECALL REQUEST
•
SCENE RECALL REQUEST (1st byte)
Specify the scene number to be recalled.
SCENE RECALL REQUEST
1 0x31
(‘1’)
2 0x32
(‘2’)
3 0x33
(‘3’)
4 0x34
(‘4’)
5 0x35
(‘5’)
6 0x36
(‘6’)
7 0x37
(‘7’)
8 0x38
(‘8’)
Example
To recall scene No,7:
0x43 0x52 0x43 0x4C 0x37 0x0D
(‘C R C L 7 CR’)
Page 18/43
