SRP-X500P RS-232C Interface Manual
2.1.12 MUTING : 0x43 0x4D 0x55 0x54 (‘CMUT’)
This command is used to turn off the specified channel (
“
Muting on”) or turn the channel back on (
“
Muting off”).
The parameter specified in this command for the MIC 1/2/WL 1/2 INPUT, MIC 3/4 INPUT, LINE INPUT,
AV/RGB INPUT, SPEAKER OUTPUT 1-4, and LINE OUTPUT 1-4 channels function in the same way as the
MUTING buttons in the BLOCK screen and the OVER VIEW screen of the SRP-X500P Manager.
Note
This command can be used only when the SYSTEM TYPE selector on the SRP-X500P is set to 0.
Packet format
0x43 0x4D 0x55 0x54
“
parameter” 0x0D
♦
Parameter
The parameter consists of 2 bytes of data in the order shown in the following table.
Byte Parameter
1st Channel
2nd MUTING
•
Channel (1st byte)
Specify muting of a channel.
The parameter and the channel selection are shown in the following table.
Channel
Channel
MIC 1/WL 1 INPUT
0x30(‘0’)
MASTER VOLUME
0x40(‘@’)
MIC 2/WL 2 INPUT
0x31(‘1’)
REMOTE 1
0x42(‘B’)
MIC 3 INPUT
0x32(‘2’)
REMOTE 2
0x43(‘C’)
MIC 4 INPUT
0x33(‘3’)
REMOTE 3
0x44(‘D’)
LINE INPUT
0x36(‘6’)
REMOTE 4
0x45(‘E’)
AV/RGB INPUT
0x37(‘7’)
REMOTE 5
0x46(‘F’)
SPEAKER OUTPUT 1
0x38(‘8’)
REMOTE 6
0x47(‘G’)
SPEAKER OUTPUT 2
0x39(‘9’)
SPEAKER OUTPUT 3
0x3A(‘:’)
SPEAKER OUTPUT 4
0x3B(‘;’)
LINE OUTPUT 1
0x3C(‘<‘)
LINE OUTPUT 2
0x3D(‘=‘)
LINE OUTPUT 3
0x3E(‘>‘)
LINE OUTPUT 4
0x3F(‘?’)
•
MUTING (2nd
byte)
Specify muting or cancellation of muting.
The parameter and the muting setting are shown in the following table.
MUTING
Muting off
0x40(‘@’)
Muting on
0x41(‘A’)
Page 14/43
