SRP-X500P RS-232C Interface Manual
♦
PROJECTOR PROTOCOL SWITCH (1st
byte)
SYSTEM TYPE SWITCH (2nd byte)
Shows the position of the PROJECTOR PROTOCOL selector or the SYSTEM TYPE selector on the
front panel of the SRP-X500P.
The parameters and the switch position are shown in the following table.
SWITCH
0 0x30
(‘0’)
1 0x31
(‘1’)
2 0x32
(‘2’)
3 0x33
(‘3’)
4 0x34
(‘4’)
5 0x35
(‘5’)
6 0x36
(‘6’)
7 0x37
(‘7’)
8 0x38
(‘8’)
9 0x39
(‘9’)
A 0x3A
(‘:’)
B 0x3B
(‘;’)
C 0x3C
(‘<‘)
D 0x3D
(‘=‘)
E 0x3E
(‘>‘)
F 0x3F
(‘?’)
♦
INPUT VOLUME (3rd-8th byte)
Shows the setting of the input level controls on the front panel of the SRP-X500P.
Byte Parameter
1st
MIC 1/WL 1 INPUT VOLUME
2nd
MIC 2/WL 2 INPUT VOLUME
3rd
MIC 3 INPUT VOLUME
4th
MIC 4 INPUT VOLUME
5th LINE
INPUT
VOLUME
6th AV/RGB
INPUT
VOLUME
The correspondence of the parameter with the level setting is the same as that of the FADER
parameter of the INPUT FADER command (page 7).
♦
MASTER VOLUME LEVEL (9th byte)
Shows the setting of the MASTER control on the front panel of the SRP-X500P.
The correspondence of the parameter with the level setting is the same as that of the FADER
parameter of the INPUT FADER command (page 7).
♦
REMOTE 1-6 LEVEL (10th-15th byte)
Shows the level of the REMOTE 1-6 faders.
The correspondence of the parameter with the level setting is the same as that of the LEVEL
parameter of the REMOTE 1-6 LEVEL command (page 10).
Page 26/43
