Page 1 of 3
Remote Microphone Connection
Procedures for the Kanso –
Roger inspiro as Transmitter
1.
Pair the MM2+ to the Kanso. (Pairing only needs to be done once, unless MM2+ has been paired to
another processor)
a.
Turn off the Kanso by pressing and holding the button for five seconds
until the indicator light turns a steady orange, then release the button.
b.
Turn on the MM2+ by pressing the ON/OFF button until the LED turns
green, then release the button.
c.
With the tip of a ballpoint pen, press the pairing button
once. The LED will flash yellow. Within 20 seconds, turn on the Kanso by pressing and holding
the button until the LED turns green, then release the button.
d.
The LED on the Kanso will blink blue, which indicates pairing is successful.
2.
Connect the Roger X receiver to the Roger inspiro transmitter. (Connecting only needs to be done once
unless the Roger X has been connected to another transmitter)
a.
Turn ON the Roger inspiro by sliding the top slider until the green mark appears.
b.
Turn ON the MM2+.
c.
Insert the Roger X into the FM connector of the MM2+.
Pairing button
