Chapter 6 Maintenance
6
6-6
6-1-3 Testing the VTR
Perform tests (1) to (7) consecutively.
(1) Testing the tape transport functions
1
Set the VTR SAVE/STBY switch to SAVE and check that the VTR
SAVE indicator in the viewfinder goes on.
2
Set the VTR SAVE/STBY switch to STBY and check that the VTR
SAVE indicator in the viewfinder goes off.
3
Set the F-RUN/SET/R-RUN switch to R-RUN.
4
Set the DISPLAY switch to CTL.
5
Press the VTR START button and check the following points.
• The tape reels are turning.
• The counter indication is changing.
• The REC indicator in the viewfinder is on.
• The RF and SERVO indicators on the display panel are off.
6
Press the VTR START button again and check that the tape stops
and that the REC indicator in the viewfinder goes off.
7
Repeat the checks of steps
5
and
6
, this time using the VTR button
on the lens.
If the REC SWITCH function is assigned to the ASSIGN 1 switch,
repeat the checks of steps 5 and 6, this time using the ASSIGN 1
button.
8
Press the RESET button and check that the counter display goes to
“00:00:00:00".
(Continued)