Chapter 5
Editing
Chapter 5
Editing
75
a) When using the component signals (CMPNT), set the
IN/OUT switch of the DSBK-170 to IN.
Selecting the i.LINK (DV) or SDTI (QSDI) signals
for input video causes the same to be automatically
selected also for input audio.
To select an input audio signal format
Press the sub LCD operation button F3,
highlighting the input audio signal indication, then
press the UP button or the DOWN button
repeatedly until the input audio signal indication
corresponding to the desired audio signal appears
in the sub LCD.
Selecting the i.LINK (DV) or SDTI (QSDI) signals
for input audio causes the same to be automatically
selected also for input video.
6
Select the audio recording mode.
Press the sub LCD operation button F2,
highlighting the audio recording mode indication,
then press the UP button or the DOWN button so
that the audio recording mode indication
corresponding to the selected mode appears in the
sub LCD.
Selectable video signals
(Input connectors)
Composite signals (VIDEO INPUT)
S-video signal (S VIDEO IN)
i.LINK (DV) signals (DV IN/OUT
(optional DSBK-140/160A))
SDTI (QSDI) signals (SDTI(QSDI)
IN (optional DSBK-150))
SDI signals (SDI IN (optional
DSBK-160A))
Component signals (Y, R–Y, B–Y
(optional DSBK-170))
Test video signal
Input video signal
indication in the
sub LCD
CMPST
S VIDEO
i.LINK
SDTI
SDI
CMPNT
a)
SG
Selectable audio signals
(Input connectors)
Analog signals (AUDIO INPUT
CH-1/CH-2)
Input audio signal
indication in the
sub LCD
ANALOG
i.LINK
SDTI
SDI
i.LINK (DV) signals (DV IN/OUT
(optional DSBK-140/160A))
SDTI (QSDI) signals (SDTI(QSDI)
IN (optional DSBK-150))
SDI signals (SDI IN (optional
DSBK-160A))
Notes
• In the DVCAM format, there are two audio
recording modes, that is, two channel, 48-kHz
mode and four-channel, 32-kHz mode. It is not
possible to select other modes (for example, four-
channel, 48-kHz mode).
• If an audio signal in a different mode than the
base tape is used in assemble or insert editing, the
signals will be discontinuous at the edit points
and correct editing will not be obtained. For this
reason, audio editing between different modes is
inhibited on this unit.
For smooth editing operations, check the audio
recording mode of the base tape beforehand. If on
a tape there is a point where the audio mode is
switched, you cannot perform an insert editing on
that point.
• Once you have started recording, you cannot
change the audio mode selection.
7
Use the AUDIO INPUT PRESET/VARIABLE
switch and the AUDIO INPUT CH 1 to CH-4 level
adjustment knobs to adjust the audio input levels.
Watching the audio level meter, adjust the levels
so that the meter does not indicate higher values
than 0 dB when the audio signals are at their
maximum.
Selectable audio recording mode
Indication in
the sub LCD
Two-channel, 48-kHz recording mode
Four-channel, 32-kHz recording mode
2/48k
4/32k
PRESET
VARIABLE
Preset to fixed levels.
Levels cannot be adjusted
with the level adjustment
knobs.
Levels adjustable with the
level adjustment knobs.
Adjust the levels while
viewing the audio level
meter in E-E mode.
AUDIO INPUT PRESET/
VARIABLE switch setting
Audio input level
adjustment
Test audio signal
SG
