6-90
HVR-Z5C/Z5E/Z5J/Z5N/Z5P/Z5U
4.
Adjustment
4-1. FWD Position Adjustment
Perform this adjustment after the tension regulator ass’y and the S-reel table ass’y are replaced or removed.
• TG1 FWD position adjustment
• FWD back tension adjustment (Refer to Page 6-93).
1) Enter the
[R/P]
mode and confirm the positions of TG1 guide and the TG2 guide.
• Confirm that the distance between the flanges on the TG1 guide and the TG2 guide is 2 mm by inserting the block gauge or the pin
gauge between them to measure. If the distance is not 2 mm, perform the following adjustment.
2) Loosen the screw and adjust the band adjuster so that the distance between the flanges on the TG1 guide and the TG2 guide becomes
2 mm using the adjustment screwdriver (Ref. No. J-25), and finally tighten the screw.
Tightening torque: 0.06
±
0.01 N•m (0.61
±
0.1 kgf•cm)
Note:
When measuring the distance between guides by inserting the block gauge or pin gauge, be very careful not to damage the roller.
Fig. 6-2-4
Band adjuster
TG1 guide
TG2 guide
TG1 nut
TG2 nut
TG1 nut
Flange on the TG1
Flange on the TG1
TG2 nut
Block gauge,
pin gauge, etc
2mm
2mm
Flange on the TG1
Flange on the TG1
Fixing screw
Adjustment
screwdriver
Band adjuster
Summary of Contents for DSR-PD198P
Page 445: ......
