![background image](http://html.mh-extra.com/html/sony/cmt-z100dir/cmt-z100dir_operating-instructions-manual_420475042.webp)
CMT-Z100iR/Z100DiR.GB.4-140-444-12(1)
42
GB
Files that are encrypted or protected by
passwords, etc. cannot be played back.
* This system supports FAT16 and FAT32, but
some USB storage devices may not support
all of these FAT. For details, see the operation
manual of each USB storage device or
contact the manufacturer.
Tuner
Severe hum or noise, or stations
cannot be received. (“TUNED” or
“STEREO” flashes in the display.)
Connect the antenna properly.
Find a location and an orientation that
provide good reception, and then set
up the antenna again.
Keep the antennas away from the
power cord and the USB cable to avoid
picking up noise.
Turn off nearby electrical equipment.
“TUNED” does not appear in the
display (DAB only).
Check all antenna connections, then
perform the DAB Automatic Scan
procedure (see “Reception of DAB
radio station (CMT-Z100DiR only)”
(page 14)).
The current DAB service may not be
available. Press +/
(or TUNE +/
on
the unit) to select a different service.
If you have moved to another area,
some services/frequencies may have
changed and you may not be able to
tune into your usual broadcast.
Perform the DAB Automatic Scan
procedure to re-register the contents of
broadcasts. (Performing this procedure
clears all previously stored presets.)
To change the AM tuning interval
(Latin American model only)
The AM tuning interval is factory-preset
to 9 kHz (or 10 kHz for some areas).
Use buttons on the unit to change the
AM tuning interval.
1
Tune in any AM station, and then
turn off the system.
2
While holding down FU,
press
.
All the AM preset stations are erased.
To reset the interval to the factory
preset, repeat the procedure.
To reset the system to factory settings
If the system still does not operate
properly, reset the system to factory
settings.
Use buttons on the unit to reset the unit
to its factory default settings.
1
Disconnect and reconnect the power
cord, and then turn on the system.
2
Press DSGX and
/
for about
3 seconds.
All user-configured settings, such as
preset radio stations, timer, and the
clock, are deleted.