![background image](http://html.mh-extra.com/html/sony/cmt-z100dir/cmt-z100dir_operating-instructions-manual_420475037.webp)
CMT-Z100iR/Z100DiR.GB.4-140-444-12(1)
GB
Additional I
nf
or
ma
tion
Additional Information
Troubleshooting
1
Make sure the power cord is correctly
and firmly connected.
2
Find your problem in the checklist
below, and take the indicated
corrective action.
If the issue persists, contact your
nearest Sony dealer.
If the STANDBY indicator flashes
Immediately unplug the power cord,
and check the following items.
If your system has a voltage selector,
is the voltage selector set to the
correct voltage?
Is anything blocking the ventilation
holes on the top or back of the
system?
Is the iPod connector short-
circuited?
After the STANDBY indicator stops
flashing, reconnect the power cord,
and turn on the system. If the issue
persists, contact your nearest Sony
dealer.
General
The display starts flashing as soon
as you plug in the power cord even
though you have not turned on the
system.
Press DISPLAY once while the system
is off. The demonstration disappears.
The system does not turn on.
Is the power cord plugged in?
There is no sound.
Is anything blocking the ventilation
holes on the top or back of the system?
The specified station may have
temporarily stopped broadcast.
There is no audio output during Rec
Timer.
The STANDBY indicator remains lit
after unplugging the power cord.
The STANDBY indicator may not turn
off immediately after unplugging the
power cord. This is not a malfunction.
The indicator will turn off after about
40 seconds.
Severe hum or noise.
Move the system away from sources of
noise.
Connect the system to a different wall
outlet.
Install a noise filter (available
separately) to the power cord.
The remote does not function.
Remove any obstacles between the
remote and the remote sensor on the
unit, and position the unit away from
fluorescent lights.
Point the remote at the system’s sensor.
Move the remote closer to the system.
Continued