2-38
DSR-300/P(E)/V1
2-19. CHANGING THE BATTERY BEFORE
END/BATTERY END AND BP
BATTERY PRESET VOLTAGE
2-19-1. Changing the Voltage (1)
The battery before end/battery end and BP battery preset
voltage can be changed as follows with an external DC
power supply from the SYSTEM MENU.
Settable range:
11.0 to 12.5 V (Battery before end/
battery end)
12.0 to 15.9 V (BP battery preset)
Settable unit:
0.1 V
Settings at shipment: Battery before end voltage: 11.27 V
Battery end voltage: 10.95 V
BP battery preset voltage: 12.97 V
Equipment required: DC power supply, Digital voltmeter,
DVCAM cassette tape
Switch settings:
LIGHT, BACK TALLY = OFF
CAMERA = COLOR BAR
Setting
1. Remove the bottom panel. (Refer to section 2-2-3.)
2. Connect the DC power supply to DC IN connector.
3. Insert a cassette tape, and set the unit into the REC
mode.
Note:
.....
Touch the lead tip of the digital voltmeter to
pin 6 (GND) and pin 12 (DC power) of
connector CN6 on the CP-315 board as
shown in Fig. 1, and adjust the DC power
supply to the desired voltage.
.....
Be careful not to touch the lead tip of the
digital voltmeter to the chassis and other
connector pins.
EARPHONE
12
6
CP-315 board
CN6 (CP-315 board)
<Bottom view>
DC IN connector
DC IN
DC power
supply
