1-12
DSR-300/P(E)/V1
Chapter 1 Overview
22
Chapter 1
Overview
Left and Upper View
Front section
1
Shoulder strap fitting
To use the supplied shoulder strap, fix one end here
and the other end to the right side. (See page 38.)
2
Accessory fitting shoe and screw hole
Attach optional video lights or other accessories here.
3
Viewfinder left-to-right position fixing ring
Loosen this ring to adjust the left-to-right position of
the viewfinder. (See page 34.)
4
Viewfinder fitting shoe
Fix the DXF-701WS/701WSCE Viewfinder here.
5
REMOTE connector 1 (mini-jack)
Connect the RM-LG1 Remote Control Unit to enable
remote operation of the ClipLink function.
Note
The RM-81 cannot be connected.
6
Viewfinder front-to-back position locking knob
Loosen this knob to adjust the front-to-back position of
the viewfinder. (See page 34.)
7
Fitting for optional microphone holder
You can fit an optional CAC-12 Microphone Holder
here. (See page 35.)
8
Video light connector
A video light with a maximum power consumption of
30 W such as the Anton Bauer Ultralight 2 or
equivalent can be connected.
1
Shoulder strap fitting
2
Accessory fitting shoe and screw hole
3
Viewfinder left-to-right positioning ring
4
Viewfinder fitting shoe
5
REMOTE connector 1
6
Viewfinder front-to-back position locking knob
7
Fitting for optional microphone holder
8
Video light connector
9
LENS connector
0
VIDEO OUT connector
!¡
REMOTE connector 2
Location and Function of Parts
Chapter 1 Overview
Chapter 1
Overview
23
9
LENS connector (12-pin)
If you use a lens with cable, connect the lens cable.
0
VIDEO OUT connector (BNC)
This outputs the video signal captured by the
camcorder.
!¡
REMOTE connector 2 (10-pin)
Connect the optional RM-M7G Remote Control Unit
to this connector. Set the CAMERA HEAD SELECT
switch on the bottom of RM-M7G to 1.
You can also connect a remote control unit with
microphone.
Note
EZ mode cannot be used if the RM-M7G is connected
to the camcorder.
For more information about a remote control unit with
microphone, contact your Sony dealer.
Rear section
1
Cassette holder
Power the camcorder and press the EJECT button to
open the lid. Insert the cassette and close the lid by
pressing the indication “PUSH” .
2
GEN LOCK IN (gen lock video input) connector
(BNC)
When synchronizing the camcorder to an external
signal, input a reference video signal (VBS or BS).
1
Cassette holder
2
GEN LOCK IN connector
3
TC IN connector
4
TC OUT connector
5
S VIDEO OUT connector
6
MONITOR OUT connector
7
AUDIO OUT CH-1/CH-2 connectors
3
TC IN (time code input) connector (BNC)
Input an external signal for synchronizing the built-in
time code generator. Use an SMPTE (DSR-300) or
EBU (DSR-300P) time code signal.
Note
Use a jitterless LTC signal. Using an LTC signal
reproduced by other equipment may cause the
camcorder to malfunction.
