Sony BVP-570, Maintenance Manual

Page: 114 / 806

5-24 (E)
BVP-570
Line Select
A
C
9. Confirm that the carrier leakage does not monitored at
portion C on the waveform monitor.
Specifications : C = Minimum
(Waveform Monitor)
File Store:
Execute the file store. Press the MENU SEL switch twice
to execute.
MENU : Reference File
PAGE : Reference File (R1)
ITEM : File Store
Resetting after Adjustment:
.
Set the menu as follows.
MENU : Paint
PAGE : Video Level (P1)
ITEM : Test
→
Off
.
WHITE BAL switch (on the side panel)
→
PRST
5-17. Flare Adjustment
Equipment : Waveform monitor
Test Point : TEST OUT connector
Object : Grayscale chart
Preparations:
.
Connect the waveform monitor to the TEST OUT
connector.
.
Shoot the grayscale chart so that the chart frame is
aligned with the underscanned monitor frame.
.
RGB/ENC switch (on the side panel)
→
ENC
. Set the DISP switch (on the side panel) from OFF to
MENU while holding down the MENU SEL switch (on
the front panel). Set the menu as follows.
MENU : Paint
PAGE : W.Clip/Knee (P6)
ITEM : Knee
→
Off
Iris of the lens
: A = 100
±
2 IRE (for NTSC)
A = 700
±
14 mV (for PAL)
(Waveform Monitor)
Adjustment Procedures:
1. Adjust the auto white balance.
WHITE BAL switch (on the side panel)
→
A
AUTO W/B BAL switch (on the front panel)
→
WHT
2. Open the iris control of the lens by two stops against
the reference setup (corresponding above A).
3. Set the RGB/ENC switch (on the side panel) to RGB.
Set the R/G/B switch (on the side panel) to G.
4. Select the 15 lines in the center of the monitor screen
by using the 15 LINE SELECT on the waveform
monitor.
5-16. Gamma Correction Adjustment
5-17. Flare Adjustment