1-11
FVS-1000 MMP1
1-10. Installation Procedure
4.
Remove the two screws, then remove the connector cover from the rear panel.
5.
Pass the connector of the air blow assembly through the hole of the connector cover, then connect it
with the connector fixed to the connector support plate.
6.
Fix the connector cover to the rear panel with the two screws (B3
x
6).
n
Put the harness inside as much as possible.
7.
Insert the tube (ø8) to the elbow (one-touch joint) of the air blow assembly.
n
Insert the tube completely, then confirm that it does not come out by pulling slightly.
8.
Insert the connecting elbow to the bulkhead union.
n
Insert the connecting elbow completely, then confirm that it does not come out by pulling slightly.
Connecting elbow
assembly
Bulkhead union
Elbow
Air blow assembly
Tube (ø8)
B3
x
6
Connector cover
Connector
Air blow assembly
