3-13
DNW-7/90/90WS
Viewfinder screen (Factory default setting)
Description
* OPERATION MODE 1 *
R-G/B-G SEL.
: OFF
........... Sets whether to add the R-G and B-G signals to the TEST OUT setting of the
setup menu.
GAMMA TABLE
: A (PAL : B)
........... Selects the characteristics of the gamma correction.
More distinct black gradation is obtained when this item is set to B.
Normally setting to A.
A
: Sony standard gamma curve
B
: High gain gamma curve
LOW LIGHT
: OFF
........... Sets the starting level of the LOW LIGHT display on viewfinder.
OFF : No display
1
: Approx. 10 %
2
: Approx. 15 %
3
: Approx. 20 %
BARS SELECT
: 1
........... Sets the type of built-in color bars signal
1
: SMPTE color bars
2
: EBU color bars (PAL)/Full color bars (NTSC)
3
: SNG color bars
WHITE B
: AWB
........... Sets the function of white balance (B-CH)
AWB : Auto white balance
ATW : Auto tracing white balance
BATT WARNING
: 10%
........... Sets the blinking (alarm) starting level of the remaining amount of battery in
ANTON BAUER Inc., battery.
10% : Starts blinking when the remaining amount of battery voltage reaches
about 0.67 V.
20% : Starts showing the 20% display when the remaining amount of battery
voltage reaches about 1.33 V, and starts blinking at about 1.0 V.
WIDE AWB
: ON
........... Widens the adjustment range of auto white balance.
ZEBRA
: OFF
........... Sets this item when a VF without the zebra switch is used.
A zebra pattern is forcibly displayed on the viewfinder screen regardless of the
VF zebra switch setting when this item is set to ON.
* OPERATION MODE 2 *
TIME CODE DISP
: OFF
........... Sets whether to output the time code to the TEST OUT connector and viewfind-
er screen.
VF
: Outputs the time code to the viewfinder only.
TEST : Outputs the time code to the TEST OUT connector only.
BOTH : Outputs the time code to the viewfinder and TEST OUT connector.
OFF
: Outputs no time code.
* SG ADJ. *
H BLKG WIDTH
: 0
........... Sets the H blanking width.
V BLKG
: 20 H
........... Selects the V blanking width. (19 H, 20 H, or 21 H)
(For NTSC only)
REC TALLY
: UPPER
........... Selects which LED is made to be lit when REC tally signal is input.
UPPER : Only the upper-middle LED
BOTH
: The upper-middle and lower-middle LEDs
3-1. Setup Menu
