1-14
DNW-7/90/90WS
1-7. Removal/Installation of Cassette
Compartment
m
.
Be sure to turn off the power, then pull out the power
cord and/or battery before performing the following
procedure. If not, damage to internal circuit may result.
.
The cassette compartment can be removed even if it
comes up or goes down.
Removal
1.
Remove the front lid and outside panel.
(Refer to section 1-6.)
2.
Remove the three screws, hold the position of the
cassette compartment shown in the figure, and remove
it in the direction indicated by the arrow.
Installation
1.
Adjust the position of the joint arm so that the clear-
ance between the white roller’s outer circumference of
a joint arm and the end face of the mechanical deck
assembly is 0.5 mm.
2.
Raise the white lock roller of the cassette compartment
so that it comes up.
1-7. Removal/Installation of Cassette Compartment
Cassette compartment
(Omit the illustration of the frame)
Mechanical deck assembly
Screws
(M 1.4
x
3.5)
Screws
(M 1.4
x
3.5)
White lock roller
0.5 mm
White roller
Joint arm
