Remove Processor Card
To unlatch the ZIF socket lever
(Figure 5)
, push the
lever down and then out to clear the side tab. Once
the level is clear of the side tab, rotate the lever up
90˚. Gently lift the existing processor card up and
out of the ZIF socket.
Install Encore/ZIF Processor Upgrade
Card
1.
Remove the Encore processor upgrade card
from the anti-static package, making sure to
handle the card by the edges
(Figure 6)
. Gently
peel the pin protection foam off the Encore/ZIF
card. Transfer the foam to the processor card
you removed from the computer. With
the foam attached, place it into the anti-static
package and store it in a safe place.
2.
Notice that one corner of the Encore/ZIF
processor upgrade card, identified as position 1,
does not have a pin
(Figure 7)
.
3.
The ZIF socket has a corner without a hole
(Figure 8)
. Align and lower the Encore/ZIF card
so that position 1 on the Encore/ZIF matches
with the corner of the ZIF socket without the
hole.
If you encounter any resistance, raise
the card and check for bent pins; then,
realign the card over the socket and gently
lower it again. Be very careful! Broken pins
are not covered under warranty.
En
5-6
Figure 5; Figura 5
ZIF socket
lever
Figure 7; Figura 7
Figure 6; Figura 6
position 1
Figure 8; Figura 8
anti-static
package
Encore/ZIF
card
Encore/ZIF
card
Encore/ZIF
card
ZIF socket
ZIF socket
processor card
corner without
hole
