animeo KNX 4 AC MoCo · REF. 5071074 -
44/47
Diagnosis
7.1 LEDs on the animeo KNX Motor Controller
The LEDs on the animeo KNX Motor Controller can be used for the following functions:
Functionality of the device during operation (230 V / KNX bus voltage connected, indication via radio signals, ...)
A limited overview of the settings
7.2 Informationen during operation
Receiving of radio message ............................................................
Safety low/high or object "block function" is active ................................
The device is ready for operation, display reception KNX telegram ..............
7.3 Status of the configuration
The call-up of the status of configuration is possible only in the delivery state, before the device was programmed with the ETS. As soon
as the device is programmed with the ETS, the status of the configuration can no longer be called up over the Reset/Prog button. When the
device is unloaded by the ETS, the status of the configuration can be called up again over the Reset/Prog button. A call-up of the status is
always possible over radio functionality (green upper LED).
LED
On (2 s)
Blinking
)
)
)
= Green
Radio operation acknowledged
No radio operation
SCR
= Yellow
Vertical awning with saved move and turn times Vertical awning without saved move and turn
times
EU
= Orange
Venetian blinds EU ergonomics with
saved move and turn times
Venetian blinds EU ergonomics without
saved move and turn times
US
= Red
Venetian blinds US ergonomics with
saved move and turn times
Venetian blinds US ergonomics without
saved move and turn times
For an explanation of EU/US ergonomics see chapter 1 Definitions.
7.
