SolarEdge SE7600A-US, Installation Manual

Page: 77 / 116

Creating an Ethernet (LAN) Connection
This communication option enables using an Ethernet connection to connect the inverter to the
monitoring platform through a LAN.
Ethernet cable specifications:
l
Cable type – a shielded Ethernet cable (Cat5/5E STP) may be used
l
Maximum distance between the inverter and the router – 100 m/ 330 ft.
NOTE
If using a cable longer than 10 m / 33 ft in areas where there is a risk of induced
voltage surges by lightning, it is recommend to use external surge protection
devices.
For details refer to: http://www.solaredge.us/files/pdfs/lightning_surge_
protection.pdf . A surge protection device is available from SolarEdge.
https://www.solaredge.com/sites/default/files/rs485_surge_protection_kit_
installation_guide.pdf
If not using surge protection, connect the grounding wire to the first inverter in the
RS485 chain; make sure the grounding wire is not in
contact with other wires. Connect the grounding wire to the grounding bus-bar in
the Connection Unit.
Figure 34: Example of Ethernet connection
To connect the Ethernet cable:
1. Remove the inverter cover as described in Removing the Inverter Cover on page 44.
2. Open the communication gland #1.
CAUTION!
The gland includes a rubber waterproof fitting, which should be used to ensure proper sealing.
Le cote interne du gland contient une rondelle qui doit être utilisée pour une bonne étancheïté.
3. Remove the plastic seal from the large opening that has a cut in the rubber fitting .
Chapter 9: Setting Up Communication to the Monitoring Platform
SolarEdge - StorEdge Installation Guide MAN-01-00262-1.3
75