SuperVisor LX
SECTION 3
FGAX3249400MANAA
100701
Version 1 Issue 2
3.5
COMPONENT INPUTS
These inputs normally accept analog component
video signals in YPbPr format via BNC connectors
that terminate in 75 Ohms.
Note that this input may be configured to accept an
RGB signal.
On early cards this is by link selection on the
IQD1ADC card.
For full details please see Section 5 “RGB input
select change and Sync level select”.
On later cards this is achieved by software control.
See Section 4, “Operation”.
COMPONENT EXT SYNC
When External syncs are selected for the analog
component signal above, the ADC will lock to a
suitable sync signal connected to the
IN
connector.
The
OUT
connector provides a buffered version of
the signal at the
IN
connector.
This input normally accepts a low level 0.3 V p-p
signal. It can be configured to accept a high level
2 V p-p signal.
For full details please see Section 5 “RGB input
select change and Sync level select”.
AUX 2 OUT
This is a component digital output of the ADC via a
BNC connector for 75 Ohms.
DIGITAL INPUTS
These are component digital inputs to the router
section of the unit via BNC connectors that
terminate in 75 Ohms. These signals may be
selected using either the Shoebox or the PC
Control program.
AUX 2 OUT
This is the component digital output of the router
section of the unit via a BNC connector for 75
Ohms.
B-Y/B
IN
R-Y/R
IN
Y/G
IN
COMPONENT
INPUTS
IN
OUT
COMPONENT
EXT SYNC
AUX 2 OUT
DIGITAL
INPUTS
AUX 2 OUT
