![background image](http://html1.mh-extra.com/html/snell-and-wilcox/supervisor-lx/supervisor-lx_operation-and-installation-manual_1309048044.webp)
SuperVisor LX
SECTION 5
FGAX3249400MANAA
100701
Version 1 Issue 2
5.1
RGB Input Select and Sync Select Notes
Important Safety Warning
These servicing instructions are for use by qualified service personnel
only. To reduce risk of electric shock do not perform any servicing other
than that contained in the operating instructions unless you are qualified to
do so. Refer all servicing to qualified personnel.
SuperVisor LX
Product Type
SuperVisor LX
Technical Note
RGB input select change and Sync level select
Date
January 2001
Warranty Terms
1. Snell & Wilcox warrants to the purchaser that new equipment will be free from defects in material and
workmanship for one year from the date of shipment by Snell & Wilcox, subject to the exclusions set out
below. Snell & Wilcox exclusive obligation (and purchasers only remedy) for any defect shall be to repair
or replace, at Snell & Wilcox option, at no charge except for shipping charges, any equipment or parts
returned prepaid to an approved Snell & Wilcox service centre.
2 Within the warranty period, purchaser shall notify Snell & Wilcox of any defect in material or workmanship.
If a part is defective, Snell & Wilcox may forward a new part to purchaser, invoice for the part and credit
invoice upon receipt of the defective part returned, freight prepaid. Snell & Wilcox reserve the right to
inspect or repair equipment on purchaser’s premises.
3 Snell & Wilcox specifically excludes the following from warranty coverage, and assumes no responsibility
for repair or replacement thereto:
a) Equipment which has been modified, repaired or altered by procedures other than those published or
authorised in writing by Snell & Wilcox, which has been subjected to misuse, misapplication, improper
maintenance, negligence, acts beyond the purchasers control (including failure of or excessive electrical
power or failure of environmental control equipment);
b) used equipment;
c) fuses, lamps and batteries;
d) equipment which has had its serial number altered, defaced or removed.
4 No repair or replacement shall extend the warranty period.
5 NOTE: Please be certain that you have received appropriate upgrade training prior to performing
upgrades; failure to complete this training will invalidate the warranty.