![background image](http://html.mh-extra.com/html/snell-and-wilcox/sd1012/sd1012_installation-manual_1309064020.webp)
Page
SD1012 Installation Manual - Issue 6, Rev 1
S&W Production & Post Production
12
SWITCHER TIMING FOR VTR PRE-READ
Introduction
Pre-read is a facility of some VTRs which allows video
information to be read from the tape, be processed by some
external equipment and then written back to the tape in the
same place as it was read from. This process allows tape to
tape editing to be carried out using only two VTRs instead of
the normal three.
Processing delay
The processing equipment will delay video passing through it
by some amount of time. This delay must be less than the
maximum delay which can be accommodated by the pre-read
VTR. Different makes and models of VTR have different
maximum delay capabilities, refer to the VTR manufacturer for
this information.
The processing delay of a Golden DaVE switcher is dependant
on how it is set-up. Absolute minimum delay is 14u sec with
no option card fitted, or 33u sec with the OPT card fitted but
with no Border Gen delay set. The maximum Border Gen
delay which can be set is 20 lines, making the maximum delay
through a Golden DaVE switcher,
with no DVE,
1313u sec.
Setting Golden DaVE
How Golden DaVE can be set and used depends on the delay
handling capabilities of the pre-read VTR being used. If the
VTR can accept a delay of 21 lines, or more, the full Colour
Correction, Chroma Keying and Border Generation facilities of
Golden DaVE can be used.
Note
DVE cannot be used with pre-read as the delay produced
by the DVE function is one full frame.
There are two standard methods of synchronising the video
sources, switcher and VTR(s) which are shown in diagrams on
the next page, these methods are:-
a)
Sync everything to studio black burst reference. In this case
the Genlock Phase of the switcher should be set to a positive
value anywhere between the actual delay of the switcher and
the maximum delay the pre-read VTR can accommodate.
b)
Use the sync O/P reference of the switcher to synchronise the
sources and VTR(s). In this case the switcher sync output
Sync Phase should be set to a negative value anywhere
between the actual delay of the switcher and the maximum
delay the pre-read VTR can accommodate.
Note
Ensure that the VTR(s) is/are set-up to be synchronised to the
external sync reference and not to the video on the tape!
Summary of Contents for SD1012
Page 1: ...INSTALLATION MANUAL SD1012...