![background image](http://html.mh-extra.com/html/snell-and-wilcox/sd1012/sd1012_installation-manual_1309064027.webp)
S&W Production & Post Production
SD1012 Installation Manual - Issue 6, Rev 1
Page 19
CONTROL PORTS AND PROTOCOLS -
continued
To adjust this setting on the BVE-9100 step-by-step:
1. Press Shift-Setup.
2. Press F3 IDC.
3. Cursor down to the SW/MON entry in the IDC list
4. Press F8 ENTRY.
5. Press F3 SERIAL IF SW'ER
6. Cursor down to DATA-5 ("TRANSMIT INTERVAL OFFSET")
7. Type in the new value required.
8. Press RET to exit the screen, saving the value. (F8 EXIT leaves the screen but does NOT
save the value.)
9. Press RET three more times to go back to the main screen.
The new value required should be determined by the Key Cut On test as described above, but
these are values we have found to be suitable in our testing.
with Sony BVS/DVS protocol:
(min delay mode)
02 to 05 inclusive
with Sony BVS/DVS protocol:
(normal mode)
10 to 13 inclusive
with GVG-4000 protocol:
(both modes)
00 to 02 inclusive
with GVG-100 protocol:
(min delay mode)
00 approx.
with GVG-100 protocol:
(normal mode)
08 approx.
Summary of Contents for SD1012
Page 1: ...INSTALLATION MANUAL SD1012...