![background image](http://html.mh-extra.com/html/snell-and-wilcox/sd1012/sd1012_installation-manual_1309064005.webp)
S&W Production & Post Production
SD1012 Installation Manual - Issue 6, Rev 1
Page v
Battery Warnings
Lithium Battery
-
There is a Lithium battery on the VME card which is mounted “piggy-back”
on the Mainframe CPU card.
If this battery is incorrectly replaced there is a danger of explosion!
Ensure that the same make and model of battery is used if replacement is
required (a manufacturer recommended equivalent may be used if the
original type is not available). Used batteries should only be disposed of
according to the manufacturers instructions. The battery must only be
replaced by a trained service technician.
Empty Holder
-
There is an empty battery holder on the MBX card in the Control Panel, this
holder is not used.
No battery should be fitted to this card!
Maintenance & Repair
There are no user serviceable parts within either the Mainframe or the Control Panel.
In the unlikely event of an equipment failure contact the Snell & Wilcox Post Production Customer
Support department, contact details below:
Telephone + 44 (0) 1799 508100 or + 44 (0) 1799 508300
Fax
+ 44 (0) 1799 508800
Cooling Fan Failure
IF THE COOLING FANS AT THE REAR OF THE SD1000 SWITCHER MAINFRAME SHOULD
STOP FOR ANY REASON, THEN THE SYSTEM SHOULD BE SWITCHED OFF IMMEDIATELY
OR PERMANENT DAMAGE MAY RESULT.
Depending on the length of time the mainframe has been run with no fan the unit may need to be
returned for checking and repair. Contact Snell and Wilcox or your Snell and Wilcox dealer to
discuss the situation.
Summary of Contents for SD1012
Page 1: ...INSTALLATION MANUAL SD1012...