![background image](http://html.mh-extra.com/html/snell-and-wilcox/sd1012/sd1012_installation-manual_1309064039.webp)
S&W Production & Post Production
SD1012 Installation Manual - Issue 6, Rev 1
Page 31
OTHER INSTALLATION PROCEDURES -
continued
Interconnection & Set-up
The Diode Buffers connect directly to the Computer Port of the Quartz panels. A standard RS-422
cable connects the Diode Buffers to the extender cable. If less than four Quartz panels are used
the Master Diode Buffer must still be used and in the connector at the end of the extender. The
extender connects to any one of the switcher mainframe serial ports.
Switcher
The protocol of the switcher port must be set to “Aux Selectable” in the Config - System - Port
Protocols menu.
Quartz Panel
Each Quartz panel has to have a different address. This is set by card-edge switches located to
the right rear of the main board. Depending on manufacture date there will be a 4 way DIP switch
and either one or two rotary HEX switches. Where there are two rotary switches they set the
address, the left one sets the high byte and the right one the low byte. Where there is only one
rotary switch the high byte (bits 4 & 5) is set by switches 3 & 4 of the DIP switch.
The high byte should be set for the address range 10H to 1FH, this is position 1 for the rotary
control or DIP 3 & 4 up. The (other) rotary switch then sets the address within this range.
The remaining two DIP switches should be set to -
DIP 1 = UP, DIP 2 = down.
The computer interface board CI-0003 (fitted as standard to the CP3200 -S7 panel) has a link to
select the communications protocol to RS232 or RS422. This link should be set to RS422. The
RS422 position is identified by a “4” (the RS232 position by a “2”).
Interconnect Diagram
Quartz Panel
CP3201 - S7
Master Diode
Buffer
Quartz Panel
CP3201 - S7
Quartz Panel
CP3201 - S7
Quartz Panel
CP3201 - S7
Diode Buffer
Diode Buffer
Diode Buffer
Switcher
Mainframe
RS-422 Cable
RS-422 Cable
RS-422 Cable
RS-422 Cable
Extender
Cable
If using less than the maximum four panels
ensure that the Master Diode Buffer is used
for one of them and is located at the end of
the Extender Cable.
NOTE.
Summary of Contents for SD1012
Page 1: ...INSTALLATION MANUAL SD1012...