![background image](http://html1.mh-extra.com/html/snell-and-wilcox/hd1012/hd1012_installation-manual_1309062037.webp)
www.snellwilcox.com
S&W Production & Post Production
HD1012 Installation Manual – V3, Issue 1, Rev 1
Page 29
OTHER INSTALLATION PROCEDURES –
continued
Remote Allocation of Aux Sources
The switcher auxiliary outputs may have their sources allocated from one or more remote panels
rather than from the switcher control panel. Snell & Wilcox do not manufacture a panel for this
function but the Quartz Electronics CP3201 - S7 Remote Panel or the Pro-Bel 6706 panel can be
used as described below.
Pro-Bel panels
The Pro-Bel 6706 control panel may used to switch signal sources to the switcher auxiliary outputs
from a location remote from the switcher control panel.
The picture below shows the Pro-Bel 6706 panel and the tables below that show the button
allocation for the different Snell & Wilcox switchers.
1
2
3
4
5
6
7
8
9 10 11 12 13 14 15 16 17 18 Pvw 1 Pvw 2 Aux 1 Aux 2 Aux 3 Aux 4 Store 1 Store 2 Matte
19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36
Cln
Pgm
Aux 5 Aux 6 Aux 7 Aux 8 Store 3 Store 4 Wash
Panel set-up
The DIL switches must be set to the following positions.
1
2
3
4
5
6
7
8
OFF OFF OFF ON OFF OFF OFF ON
The Panel Address rotary hex switch selects which Aux output will be controlled by the panel as
detailed below.
1 = Aux Bus 1 source selection.
5 = Aux Bus 5 source selection.
2 = Aux Bus 2 source selection.
6 = Aux Bus 6 source selection.
3 = Aux Bus 3 source selection.
7 = Aux Bus 7 source selection.
4 = Aux Bus 4 source selection.
8 = Aux Bus 8 source selection.
9 through to 0 = the Aux Bus is selected from the panel.
Connecting the panels to the switcher
One or more panels may be connected to one switcher port to give independent control of each
Aux. This is achieved by using the RS485 loop connector on the Pro-Bel rear panel to connect to
the next panel. The Aux to be controlled by a particular panel is set by the address rotary switch as
described above.
Switcher set-up for Pro-Bel panels
The switcher serial port to which the panel is connected must be set to “Aux Ctrl ProBel”