![background image](http://html1.mh-extra.com/html/snell-and-wilcox/hd1012/hd1012_installation-manual_1309062019.webp)
www.snellwilcox.com
S&W Production & Post Production
HD1012 Installation Manual – V3, Issue 1, Rev 1
Page 11
SYSTEM INTERCONNECTION -
continued
Multiple Monitor Mode
Multiple Monitor Mode is a set-up that allows monitoring of M/E program and preview as well as
P/P program and preview.
Four manitors are connected to the switcher mainframe as shown below and the switcher is set-up
using the Configure - Output Setup menu.
Clean
Preview 1
Program
M/E
Preview
M/E
Program
P/P
Preview
DSK
Program
HD1000
Preview 2
The Clean Output button (F2R) allows the signal
on the Clean Program O/P to be switched
between Clean, DSK and DSK Pvw. This button
is NOT used in the above Multi Monitor Mode.
F1R (Multi. Pvw) toggles between Enabled and
Disabled, when in Enabled the Clean Output
button does not function and the signal on the
Clean O/P is forced to M/E Program, the
selections for Preview 1 are limited to the P/P &
DSK signals and the signal on Preview 2 is
forced to M/E Pvw. I.e., the Preview 2 selection
buttons do not function.