![background image](http://html1.mh-extra.com/html/snell-and-wilcox/hd1012/hd1012_installation-manual_1309062027.webp)
www.snellwilcox.com
S&W Production & Post Production
HD1012 Installation Manual – V3, Issue 1, Rev 1
Page 19
CONTROL PORTS AND PROTOCOLS -
continued
To adjust this setting on the BVE-9100 step-by-step:
1. Press Shift-Setup.
2. Press F3 IDC.
3. Cursor down to the SW/MON entry in the IDC list
4. Press F8 ENTRY.
5. Press F3 SERIAL IF SW'ER
6. Cursor down to DATA-5 ("TRANSMIT INTERVAL OFFSET")
7. Type in the new value required.
8. Press RET to exit the screen, saving the value. (F8 EXIT leaves
the screen but does NOT save the value.)
9. Press RET three more times to go back to the main screen.
The new value required should be determined by the Key Cut On test as described above, but
these are values we have found to be suitable in our testing.
with Sony BVS/DVS protocol:
02 to 05 inclusive
with GVG-4000 protocol:
00 to 02 inclusive
with GVG-100 protocol:
00 approx.
Therefore a setting of 02 allows both Sony BVS/DVS and GVG-4000 protocols to be used without
further adjustment.