www.snellwilcox.com
Page
HD1012 Installation Manual – V3, Issue 1, Rev 1
S&W Production & Post Production
28
OTHER INSTALLATION PROCEDURES
Setting the Real-Time Clock
It is recommended that you set the Real-Time Clock at installation time. To do this, press the
CONFIG button near the bottom-left of the display, then press
F2L User
and then the
F5L Set Clock
button. Adjust the knobs along the bottom of the screen to the desired date & time.
When ready, press the
F6R Set Clock
button.
There is no automatic correction for Daylight Saving Time - in areas where DST is implemented the
clock will have to be manually adjusted twice a year.
For more details about this menu, see User Manual.
System Reboot
If required, the system can be rebooted without powering off and on.
To do this, hold down the four FTB buttons (FTB ENABLE, TIME, CUT & AUTO) at the right-hand
end of the control panel at the same time as the DSK, Program & Preset bus BLACK buttons at the
left-hand end of the control panel. Keep these buttons held down, and after five seconds all
buttons will light green for two seconds, then amber for two seconds, then red for two seconds (all
times approximate). They will then all extinguish and the system will reboot.
No stored data (DMEMs, stills, configs, etc.) will be lost as a result of this process.
