SMW SPACESAVER 2400S, Installation, Operation And Maintenance Manual

Page: 62 / 86

Chapter 4 – Operation
4-36
SS2400T/S
Feeding by the 2nd spindle of the lathe; new bar loading to stopper (SS2400S)
Parameter
Value Note
#100 48.3 mm 48.3 = 15 + 3 + 0.3 + 30
#101 ??? Depends on the pusher sag.
#300 35 % ---
#010 Stopper ---
#105 18.3 mm
(1)
18.3 = 15 + 3 + 0.3
#106 0 mm ---
#107 0 mm
(1)
Parameter is not used.
#011
Magazine Only
---
#102 ??? Specific distance to the clamping device face.
#301 1 s Usual value.
#003 Stand Still ---
#004
OFF
---
(1)
As Magazine Only (#011) is set, it is necessary to enter the feeding length (#105, or #106).
In this case these parameters mean the length to be deducted by the barfeeder from the
length of the bar. it is very important for correct evaluation of the bar end. As the feed of the
new bar in front of the clamping device is controlled by the stopper in the lathe, it is not
necessary to enter the parameter #107. The value saved in it is ignored.
Feeding by the 2nd spindle of the lathe; new bar loading to the position (SS2400S)
Parameter
Value Note
#100 48.3 mm 48.3 = 15 + 3 + 0.3 + 30
#101* ??? Depends on the pusher sag.
#300 35 % ---
#010 Position ---
#105 18.3 mm
(2)
18.3 = 15 + 3 + 0.3
#106 0 mm ---
#107 11.5 mm 11.5 = 10 + 1.5
#011 Magazine Only ---
#102 ??? Specific distance to the clamping device face.
#301 1 s Usual value.
#003 Stand Still ---
#004 OFF ---
(2)
As the Magazine Only (#011) is set, it is necessary to set the feeding length (#105, or
#106). In this case these parameters mean the length to be deducted by the barfeeder from
the length of the bar. It is very important for correct evaluation of the bar end.