SMW SPACESAVER 2400S, Installation, Operation And Maintenance Manual

Page: 43 / 86

Chapter 4 – Operation
SS2400T/S
4-17
4.10.1.2 PARAMETER TYPES
4.10.1.2.1 PARAMETERS OF LIST TYPE
The parameters of list type are enumerative parameters #000 to #099. Current value of these
parameters is identified by .
How to change the value of the list type parameter
•
Select the value using and confirm it by .
4.10.1.2.2 PARAMETERS OF POSITION TYPE
Parameters of position type are numeric parameters #100 to #199, which express certain
position or length. These parameters can be entered both in mm and inches.
How to change the value of the position type parameter
•
Select suitable units using , rewrite the value, and confirm it by .
•
For some of these parameters it is possible to use the key . After pressing the key
the parameter takes over the current value of the flag position. This can be used, for
example, in the setting of the parameter #101, #102 etc.
If this key is not available, the parameter either does not support it or it is necessary first
to go to a reference.
4.10.1.2.3 PARAMETERS OF OTHER TYPE
Parameters of other type are other nonlinear numeric parameters #300 to #399.
How to change the value of the other type parameter
•
Rewrite the value and confirm it by .
4.10.1.2.4 JOB SELECTION FUNCTION
Job Selection is a function which enables archiving the value of technological parameters as
described hereinafter. This function can be referred to using the parameter #400.