SMW SPACESAVER 2400S, Installation, Operation And Maintenance Manual

Page: 25 / 86

Chapter 3 – Installation
SS2400T/S
3-5
c) Anchoring
After proper alignment, fasten the
Barfeeder to the ground by means
of expansion anchor screws (2 per
each leg).
•
Drill holes according to
dimensions of the delivered
anchor screws. The holes
must be sufficiently deep. The
screws must not seat on the
bottom of the hole.
•
Insert the screws in the holes,
and tighten them properly.
Fig.3.3 Barfeeder Anchoring
d) Final Alignment
•
It is possible that small position corrections will be necessary to finish the barfeeder
alignment. Repeat the procedure described in p. b), but move with the barfeeder only on
the fastened pad 3.1/8.
•
After alignment, tighten all screws and lock nuts (connection of the leg with the pad and
vertical alignment) and recheck the barfeeder alignment. Final alignment tolerance
should be
±
0.2 mm.
•
After the alignment, dismantle the setting kit and store it for eventual future use.
3.3 ELECTRICAL CONNECTION
•
Interconnect the barfeeder and lathe interfaces.
•
Set the barfeeder transformer to proper supply voltage.
•
Install fuses F1, F2 of proper values see Chapter 5.3.6.
Note: Some types of lathes use a single cable harness for both power and communication
conductors, while other types use two separate harnesses. The barfeeder connection is modified
accordingly.
Fuses F1, F2
Supply voltage selection
Interface X2
Interface X1
Fig.3.4 Electrical Connection