HRX-OM-M005
Chapter 5 Product Operation
5.3 Operation Screen
HRZD Series
5-48
5.3.30 CH1(2) circulating fluid discharge pressure limit setting screen
The Circulating Fluid Discharge Pressure Limit Setting screen enables the setting
of a limit to discharge pressure of the circulating fluid. The setting overrides the
Pump ECO Limit.
Figure 5-78 “Circulating Fluid Discharge Pressure Limit Setting Screen”
Table 5-33 “Circulating Fluid Discharge Pressure Limit Setting Screen”
No.
Item
Setting
range
Descriptions
Factory
default
1
[SEL] key
ON, OFF
The LIMIT value is displayed on the “Status screen 1”
when this is valid (set to ON). Discharge pressure of the
circulating fluid must remain below the limit.
OFF
2 [SET]
key
―――
Used to display the “Ten-key screen”.
2.0MPa
3 [Enter]
key
―――
Used to display the “MESSAGE screen” to accept the
setting.
－
4 [Initial]
key
―――
Used to display the “MESSAGE screen” to initialize the
setting.
－
5 [Cancel]
key
―――
Used to cancel the setting.
－
6 [Return]
key
―――
Used to display the “CH1(2)” on page 5-44.
－
[Tips]
The setting of a LIMIT value takes effect only when the [ENTER] key is
touched with ON-OFF setting set to ON.
The setting range is displayed on the “Ten-key screen” with the touch of the
[SET] key.
5 6
4
3
1
2
Summary of Contents for HRZD020-W1S-W1S
Page 24: ...HRX OM M005 Chapter 2 Name of Each Section 2 1 Name of Each Section HRZD Series 2 2 ...
Page 98: ...HRX OM M005 Chapter 5 Product Operation 5 3 Operation Screen HRZD Series 5 54 ...
Page 128: ...HRX OM M005 Chapter 8 Appendix 8 8 Thermo Chiller Daily Inspection Sheet HRZD Series 8 20 ...
