C
HAPTER
17
| SNMP Commands
– 157 –
R
ELATED
C
OMMANDS
snmp-server host
This command specifies the recipient of an SNMP notification. Use the no
form to remove the specified host.
S
YNTAX
snmp-server host <host_ip_address> <community-string>
no snmp-server host
host_ip_address - IP of the host (the targeted recipient).
community-string - Password-like community string sent with the
notification operation. Although you can set this string using the
snmp-server host command by itself, we recommend that you
define this string using the snmp-server community command
prior to using the snmp-server host command. (Maximum length:
23 characters)
D
EFAULT
S
ETTING
Host Address: None
Community String: public
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
The snmp-server host command is used in conjunction with the snmp-
server enable server command to enable SNMP notifications. You can
configure up to four host IP addresses. A separate snmp-server host
command must be entered for each host.
E
XAMPLE
AP(config)#snmp-server host 1 10.1.19.23 batman
AP(config)#
R
ELATED
C
OMMANDS
snmp-server enable server (156)
snmp-server trap
This command enables the access point to send specific SNMP traps
(i.e., notifications). Use the no form to disable specific trap messages.
S
YNTAX
snmp-server trap <trap>
no snmp-server trap <trap>
Summary of Contents for EliteConnect SMCE21011
