SMC Networks EliteConnect SMCE21011, User Manual, Page: 143 / 258

– 143 –
14
S
YSTEM
L
OGGING
C
OMMANDS
These commands are used to configure system logging on the access
point.
logging on
This command controls logging of error messages; i.e., sending debug or
error messages to memory. The no form disables the logging process.
S
YNTAX
[no] logging on
D
EFAULT
S
ETTING
Disabled
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
The logging process controls error messages saved to memory. You can
use the logging level command to control the type of error messages that
are stored in memory.
E
XAMPLE
AP(config)#logging on
AP(config)#
Table 11: System Management Commands
Command Function Mode Page
logging on Controls logging of error messages GC 143
logging host Adds a syslog server host IP address that will receive
logging messages
GC 144
logging console Initiates logging of error messages to the console GC 144
logging level Defines the minimum severity level for event logging GC 145
logging facility-type Sets the facility type for remote logging of syslog
messages
GC 145
logging clear Clears all log entries in access point memory GC 146
show logging Displays the state of logging Exec 146
show event-log Displays all log entries in access point memory Exec 147