SMC Networks EliteConnect SMCE21011, User Manual, Page: 162 / 258

C
HAPTER
17
| SNMP Commands
– 162 –
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
◆
Up to 10 SNMPv3 users can be configured on the access point.
◆
The SNMP engine ID is used to compute the authentication/privacy
digests from the pass phrase. You should therefore configure the
engine ID with the snmp-server engine-id command before using
this configuration command.
◆
Users must be assigned to groups that have the same security levels. If
a user who has “AuthPriv” security (uses authentication and
encryption) is assigned to a NoAuthNoPriv, the user will not be able to
access the database. An AuthPriv user must be assigned to the group
with the AuthPriv security level.
E
XAMPLE
AP(config)#snmp-server user
User Name<1-32> :chris
Group Name<1-32> :RWPriv
Authtype(md5,<cr>none):md5
Passphrase<8-32>:a good secret
Privacy(des,<cr>none) :des
Passphrase<8-32>:a very good secret
AP(config)#
snmp-server targets
This command configures SNMP v3 notification targets. Use the no form to
delete an SNMP v3 target.
S
YNTAX
snmp-server targets <target-id> <ip-addr> <sec-name> udp-port
<port-number> [notification-filter-id]
no snmp-server targets <target-id>
target-id - A user-defined name that identifies a receiver of SNMP
notifications. (Maximum length: 32 characters)
ip-addr - Specifies the IP address of the management station to
receive notifications.
sec-name - The defined SNMP v3 user name that is to receive
notifications.
udp-port - The UDP port that is used on the receiving management
station for notifications.
notification-filter-id - The name if a defined notification filter.
D
EFAULT
S
ETTING
None