SMC Networks EliteConnect SMCE21011, User Manual, Page: 195 / 258

– 195 –
25
E
THERNET
I
NTERFACE
C
OMMANDS
The commands described in this section configure connection parameters
for the Ethernet port and wireless interface.
interface ethernet
This command enters Ethernet interface configuration mode.
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Global Configuration
E
XAMPLE
To specify the 10/100Base-TX network interface, enter the following
command:
AP(config)#interface ethernet
AP(if-ethernet)#
Table 23: Ethernet Interface Commands
Command Function Mode Page
interface ethernet Enters Ethernet interface configuration mode GC 195
dns primary- server Specifies the primary name server IC-E 196
dns secondary- server Specifies the secondary name server IC-E 196
ip address Sets the IP address for the Ethernet interface IC-E 196
ip dhcp Submits a DHCP request for an IP address IC-E 197
shutdown Disables the Ethernet interface IC-E 198
bridge-link path-cost Configures the spanning tree path cost of a
port
IC 198
bridge-link port-
priority
Configures the spanning tree priority of a
port
IC 199
show interface
ethernet
Shows the status for the Ethernet interface Exec 200