SMART Board Board 600i6, Configuration And User'S Manual

Page: 51 / 117

C H A P T E R 5
Maintaining your interactive whiteboard system
38
l
When replacing the projector lamp module:
o
Put the projector into Standby mode and wait 30 minutes for the lamp to cool
completely.
o
Do not remove any screws other than those specified in the lamp replacement
instructions.
o
Wear protective eyewear whilst changing the lamp module. Failure to do so can
cause injuries including loss of eyesight if the lamp shatters or bursts.
o
Use only replacement lamp modules approved by SMART Technologies. Contact
your authorised SMART reseller for replacement parts.
o
Never replace the lamp module with a previously used lamp module.
o
Always handle the fragile lamp assembly with care to prevent premature lamp failure
or exposure to mercury. Use gloves when touching the lamp module. Do not touch
the lamp with your fingers.
o
Recycle or dispose of the lamp module as hazardous waste in accordance with local
regulations.
You need a Phillips No. 2 screwdriver and a flat screwdriver to complete these procedures.
To remove the old lamp module
1. Press the
Power button twice on the remote control or the ECP to put the projector into
Standby mode.
2. Wait at least 30 minutes for the projector to cool down.
3. Disconnect the power cable from the projector.
4. Use a Phillips screwdriver to loosen the two captive screws.
Lamp Door