SMART Board Board 600i6, Configuration And User'S Manual

Page: 87 / 117

A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
74
Command Response Powered off
get sysoutputsw sysoutputsw =
[current]
no
Field definitions
Field Possible values Description
target volume
l
+ val
l
– val
l
= -20 to 20
Spec or – will cause volume to be
incremented or decremented from its current
value. Specifying a numerical value within the
possible range causes volume to be set
directly to that value. When the volume is
modified from the RS232, the OSD volume
slider should also appear on the screen
identical to the slider that appears when using
the other control. Note that -20 should map to 0
and 20 should map to 40.
current volume
l
-20 to 20 The device’s current volume. Note that -20
should map to 0 and 20 should map to 40.
target mute
l
= on
l
= off
Specifies whether mute is enabled or disabled.
current mute
l
= on
l
= off
Current state of the mute
current volumecontrol
l
= on
l
= off
Current state of the volume control
target volumecontrol
l
= on
l
= off
Specifies whether volume control is enabled or
disabled.
target cc
l
= cc1
l
= cc2
l
= off
Closed captioning states
current cc
l
= cc1
l
= cc2
l
= off
Closed captioning states
target sysoutputsw
l
= line+spkr
l
= line
l
= spkr
l
= none
Specifies whether the system output switch is
line out only, speaker only, both, or none.
current sysoutputsw
l
= line+spkr
l
= line
l
= spkr
l
= none
Current state of system output switch.