SMART Board Board 600i6, Configuration And User'S Manual

Page: 81 / 117

A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
68
Field Possible values Description
target usb1source
l
= VGA1
l
= HDMI1
l
= Disabled
Value to set the usb1 switch enabled source
to. Note that this should not be the same as
the usb2source. If it is, USB1 will be used and
USB2 is ignored.
current usb2source
l
VGA1
l
HDMI1
l
Disabled
Current value that the USB2 switch will be
enabled for.
target usb2source
l
= VGA1
l
= HDMI1
l
= Disabled
Value to set the usb2 switch enabled source
to. Note that this can not be the same as the
usb1source. If it is, USB1 will be used and
USB2 is ignored.
Example:
> set input=vga1
input = vga1
> set input=next
input = composite
> get videoinputs
videoinputs = vga1, composite, hdmi1
> get usb1source
usb1source = vga1
> get usb2source
usb2source = hdmi1
> set usb2source = hdmi1
usb2source = hdmi1
>
Video Control
Video output related controls. The range of values used for these commands should match the
range displayed visually on the OSD. The firmware must handle videofreeze and videomute
states correctly. A change should be made to ensure that videofreeze and videomute are
mutually exclusive.
Command\response definitions
Command Response Responds when powered off
set displaymode [target] displaymode =[current] no
get displaymode displaymode =[current] no
set brightness [target] brightness=[current] no