SMART Board Board 600i6, Configuration And User'S Manual

Page: 107 / 117

A P P E N D I X C
Disabling user USB access
94
5. Locate the jumper cover between the “PC” and “SE240” labels on the side of the ECP that
faces the wall.
6. Using a pair of wire cutters, cut through the two tabs on the jumper cover and remove it from
the ECP. Keep the jumper cover in a safe place.
To remove the USB jumper switch
1. Locate the USB jumper behind the jumper cover port.
2. Using long-nose pliers, pull the jumper from the two connection posts and then place it on a
single post.
I M P O R T A N T
o
Only adjust the jumper position. Do not adjust the PC/SE240 switch, which is also
accessible from this area.
o
Do not discard the jumper. Discarding the jumper makes the USB deactivation
difficult to reverse.
3. Insert the USB jumper cover into the USB A port on the front of the ECP.
4. Connect all cables to the ECP. See the Using the Extended Control Panel (ECP) on page
23 for more information.
5. Secure the ECP to your interactive whiteboard with the two screws that you removed
previously.
6. Connect the projector’s power cable to the power socket.