20/11/2020
29/60
E_MH_Instalation_instructions_Skylux_Climax_Panorama
Supports and side supports
Supports and side supports
Assembly
The number of supports and their position is determined in relation to the glazing and the load. Check the length of the support with
regard to the depth of the conservatory and the load (g snow and wind); see the graphs on pages 47 - 51 or use the Climafast
calculation application.
The total sheet width of polycarbonate or acrylic plastic sheets is used except for the left and/or right sheet which may be cut to fit.
The axis distance between the AX supports = sheet width + 22 mm. Take into account a lateral clearance of 5 mm on each side. All
useful information for the processing and installation of glazing plastics can be found on pages 16 & 17.
The total width is divided into equal parts of max. 750 mm when using glass. The glazing quantity is determined as follows: (B – 60
mm)/ 750 rounded off upwards. The width of the glazing is determined as follows:
((B – 60 mm) / glazing units) – 22 mm. Please follow the instruction of your supplier for the glass.
Mark out the positions of the supports on the hinge profiles (on the gutter and wall) and check the axis-on-axis measurements.
STANDARD INSTALLATION FOR PLASTIC SHEETS
AX = PL + 22 MM
AX
AX
AX
B
Position the assembled side supports on hinges S1 or S2.
The supports at the wall and gutter side must be anchored
in hinge profile S1 or S2 using ZSG screws. Do this on the
marked line that can be seen on the bottom side of hinge
profile S. First drill using a Ø of 4 mm for supports with steel
reinforcement.
Slide sheet supports TP(G) as far up as possible against the
wall profile and fasten them using 2 ZSG screws using a
neoprene seal. Ensure that all gutter side stop profiles area
aligned.
TP(G)
ZSC
S1/S2
TP
ZSC
S1
S1
ZSG
GDG
