SKF LINCOLN P203, Original Assembly Instructions

Page: 42 / 88

EN
5. Delivery, returns, and storage
- 42 -
951-171-021
Version 02
5. Delivery, returns, and storage
5.1 Delivery
After receipt of the shipment, check the
shipment for damage and completeness
according to the shipping documents. Im-
mediately report any transport damages to
the forwarding agent.
Keep the packaging material until any dis-
crepancies are resolved. During in-house
transport ensure safe handling.
5.2 Returns
Clean all contaminated parts before return-
ing them. If this is not possible or if it does
not make sense, e. g. for the troubleshooting
in case of a complaint, make sure to indicate
the pumped material.
In case of products contaminated with
hazardous substances according to GHS
respectively CLP regulations, also send the
corresponding safety data sheet (SDS) and
mark the packaging accordingly.
The choice of packaging depends on the
specific product and the expected loads
during transport (e.g. mechanical impacts,
necessary corrosion protection measures in
case of sea transport).
In case of wooden packaging observe the
respective import regulations and IPPC
standards. Add the required certificates to
the shipping documents.
Mark returns on the packaging at least as
follows.
5.3 Storage
SKF products are subject to the following
storage conditions:
○
dry, dust- and vibration-free in closed
premises
○
no corrosive, aggressive materials at the
place of storage (e. g. UV rays, ozone)
○
protected against pests and animals (in-
sects, rodents, etc.)
○
possibly in the original product packaging
○
shielded from nearby sources of heat and
coldness
○
in case of high temperature fluctuations
or high humidity take adequate measures
(e. g. heater) to prevent the formation of
condensation water
Before application inspect the
products with regard to possible
damages occurred during their
storage. This particularly applies
for parts made out of plastic
(embrittlement).