Siqura C-60 E-MC, User Manual, Page: 48 / 142

Siqura C-60 E-MC
Page 42
10.4.2.2 Making a Video Connection
Creating a video link between a video encoder and a decoder involves two steps:

configuring the encoder's settings

configuring the decoder's settings

To configure the encoder's settings
1. Open the encoder's web pages, go to the Video page, and select the appropriate Encoder
tab.
2. In the Transmitter Settings section, specify the destination IP address.
This is the address of the video decoder that will be receiving the video stream.
3. Enter the decoder's port number.
For more information, see Port Numbers (on page 126).
4. Select
Enable
.
5. Press Save .
Video Transmitter Settings (encoder).
Transmitter 1 enabled, holding the decoder IP address and input port number.
An input port number must be used only once per device.

To configure the decoder's settings
1. Open the decoder's web pages, go to the Video page, and select the Decoder tab.
2. In the Receiver Settings section, specify the source IP address.
This is the address of the video encoder that will be transmitting the video stream.
3. Enter the decoder's own port number.
For more information, see Port Numbers (on page 126).
4. Select Enable .
5. Press
Save
.
Video Receiver Settings (decoder).
Receiver 1 enabled, holding the encoder IP address and the decoder input port number.
An input port number must be used only once per device.
With these settings configured correctly, the video link will be established. The decoder will take
the video stream from the encoder, detect the video format and use the appropriate decoding
algorithm to convert the stream to an analog output signal.
Note: Source and destination IP addresses can be unicast or multicast. For more information, see
Multicasting (on page 125).
Highlighted fields
The source address and port number fields are highlighted in green when the enabled receiver
receives a stream from the specified source. The two fields are marked in red when no stream is
received with the receiver enabled and correctly configured.