Siqura C-60 E-MC, User Manual, Page: 107 / 142

Working with the Web Pages
Page 101
TCP Server Settings
TCP Server Settings
TCP connections are always bidirectional, so no separate transmitter and receiver settings are
needed.
TCP Server Settings
Server enable Selecting this box enables the streaming of UART data over TCP using a
client/server connection. The server accepts requests from a specific client, or
any host if not specified.
Server port Range: [0...65535].
10.6.1 Advanced Settings
RS-4xx Settings
Advanced Settings, RS-4xx
For details about „data words‟ and data transfer optimization, see the note below.
RS-4xx Settings
Bit rate Range: [300...115200]. The speed of the digital transmission, that is - the amount
of information transferred/processed per unit of time. Enables you to set a bit rate
other than the presets in the UART settings section.
UART gap timeout Range: [0...255] data words. Will have the next packet sent when the line has
remained idle for longer than the timeout.
UART max. latency Range: [0...255] data words. The maximum latency of the data channel is
controlled by forcing a packet to be sent when the first data word of the packet
was received longer ago than the number of word times set here.
Line termination enable Normally, the devices at the two extremes of a bus are terminated, while
intermediate devices are not. Therefore: RS-422, always enable (being
point-to-point); RS-485, enable only for the first and last module connected to the
bus configuration.
Line biasing enable If biasing is needed (RS-485), it should be enabled on at least 1 module on the
bus. RS-422 does not require biasing.