Siqura C-60 E-MC, User Manual, Page: 126 / 142

Siqura C-60 E-MC
Page 120
Advanced Settings
For various reasons you may want to downgrade the C-60 E-MC firmware to the original
factory-installed image kept in the fixed image area. This can be done in the Advanced Settings
section of the Firmware tab.

To revert to the C-60 E-MC's fixed image
1. On the Device Management page, open the
Firmware
tab.
2. Click Advanced >> .
3. Click
Revert to factory version
.
4. To confirm the removal of the upgraded firmware, press
Continue
.
Progress of the downgrade process is shown under the Revert to factory version button.
Important:
Do not leave the Firmware tab or close your browser during the downgrade
procedure.
A "Successfully reverted to version ..." message indicates a successful downgrade.
5. Click refresh now to refresh the web page immediately, or wait for it to refresh automatically
after 30 seconds.
6. Log on to the unit again.
On reopening the Firmware tab, the Current Version section has the version number of the
factory-installed image.
10.11.6 Reboot tab
Device Management page, Reboot options
Reboot
Reboot Reboots the unit without resetting variables.
Reset to factory settings:
keep network settings Reset option for all variables that can be set by the user, with the exception of the
network settings.
Reset to factory settings;
incl. network settings A complete reset which will restore the unit's settings, including the IP
address/subnet mask, to their original, default values. This could make the unit
unreachable for in-band communications, in which case the internal web pages
are accessible only by (temporarily) moving a PC to the same subnet as the C-60
E-MC.