MultiXplo / MultiTox
Page 20 / 60
NOSP15759-Rev 10
4.2.
Assembly
Use two 6 mm diameter screws to secure the support.
It is highly recommended to install the support with cable-gland downward in order to avoid
water infiltrations. In case of horizontal position, it is advised to make one or two loops with
the cable at the entry of the cable-gland.
When mounting the cable gland (optional), if no tightening torque is specified by the
manufacturer, consider than a tightening torque of 20N.m +/-10% is the most suitable.
On stainless steel housings, plugs are sealed with Loctite. If the plugs are moved or
removed, it must be sealed again, using Loctite or equivalent.
On aluminium housings, plugs are equipped with seals.
Figure 3: Drilling dimensions for support fixing.
4.2.1.
Detector’s assembly
Check the presence of the O-ring on the explosion proof seal, make sure that it is correctly
greased and has no visible damage.
Plug the connectors to the base, as described in paragraph “Electric connection”.
Fit the main housing on the base, placing the excess of cable in the base.
Make sure to correctly tighten the 2 fixing screws once the correct position has
been obtained.
Figure 4 : Housing orientation
Summary of Contents for DM-TT6-K
