Simtronics DM-TT6-K, Operating Manual

Page: 43 / 60

MultiXplo / MultiTox
Page 43 / 60 NOSP15759-Rev 10
6.7.6. [INH]ibition submenu
Maintenance inhibition can be configured in « frozen » mode (factory setting) or « free »
mode. For further details, please, refer to §6.2
•
In « frozen» mode, the outputs (current and relay) remain in their previous state.
For example, if the device displays a fault (2.0 mA), it will remain in this mode during
the inhibition.
• If the device is configured in « free » mode, the current output will remain at the
same level than the permanent inhibition
6.8. The maintenance menu [MAIN]
The maintenance menu allows the user to check if the detector is in normal operation
conditions
• (Test of the relay and current outputs).
6.8.1. TEST sub-menu
Relay menu
This menu gives access to activation or deactivation of the relays.
The detector goes to inhibition mode. The detector will stay in inhibition mode if the user
goes back through the steps to the main menu. Otherwise, the detector will return to its
“current” state.
The 4-20 mA screen
This menu allows the output current to be set at a chosen value. The possible output values
are: 2mA, 4mA, 8mA, 12mA, 16mA, 20mA or 22mA.
During this phase, the detector goes automatically to inhibition mode. The detector will stay
in inhibition mode if the user goes back through the steps to the main menu. Otherwise, the
detector will return to its “current” state.
6.8.2. NETWORK sub-menu
This menu gives direct access to different tests for the network. For any further details,
please refer to the additional network operating manual:
• SPIN sends the detectors network identification.
•
LIEN switches from normal mode to logic link mode.
•
SWITCH enables the switches to go on mode open/closed/open secured.